•
•
Lightweight Removable Control
Mechanism
Field Changeable for Fail Safe
or Fail Secure Operation
•
•
•
Outdoor Rated & Easy to Assemble
Linear Action Centering
Shock Absorption at all Impact
Points
•
•
Hinge Door Service Access
Large Block Terminals for Field
Connections
•
1-1/8” thick Hard Coated Ratchets
with 1” thick Hard Coated Pawls
Now Part of
Full Height Galvanized Steel
Turnstile Series
AT-FST Series
The AT-FST full height galvanized steel turnstile series provides superior access
control through solid construction and safe design. These units are rated for outdoor
use and are hot dip galvanized finish.
This unit was developed with the installer in mind and can be assembled in a fraction
of the time it takes to install comparable industry models. Should requirements
change after installation, a user can easily change these units (that come electrically
pre-configured) from fail-safe to fail-secure.
To prevent shock and vibration from transferring through the turnstile frame, all
areas where mechanical impact occurs during normal operation (ratchets and
mechanism mounts) are insulated with shock absorbing materials. This unique
design assures a quiet and smooth operation of the turnstile and adds to the life of
all mechanical parts.
Linear does not charge extra for safety! Included with every turnstile are the
following safety features: Heel protection, Home Position centering of spindle and
Relocking timer.
Easy access to the operating mechanism, control board(s) and other components located in the header area
is accomplished through hinged panel doors that are key lockable. All bearings are permanently lubricated
requiring no scheduled maintenance. The lower spindle bearing is located inside the spindle column and will
not be exposed to salt, sweep cleaners or other floor maintenance materials that could cause failure. All shafts
and hardware are made from stainless steel.
d e f i n i T i O n s :
1. Fail-Safe: Upon loss of electrical power the turnstile center spindle will rotate freely in the entrance or exit direction
that is selected with this option from the ORDERING GUIDE.
2. Fail-Secure: Upon loss of electrical power the turnstile center spindle will remain locked in the entrance or exit
direction that is selected with this option from the ORDERING GUIDE.
3. Locked: The center spindle will always be locked in the entrance or exit direction that is selected with this option
from the ORDERING GUIDE.
4. Manual: The center spindle will always freely rotate in the entrance or exit direction that is selected with this option
from the ORDERING GUIDE.
c a u T i O n :
For safety reasons do not combine electrically controlled and manually controlled on the same center spindle.
aT-fsT series (single) - dimensiOnal drawings
60
152.4
53
134.6
in
cm
Header & Cover
10
25.4
Spindle Arm Section
Passage Panel
(1 of 3 shown)
80
203.2
Barrier
in
cm
aT-fsT series (dOuble) - dimensiOnal drawing
96
243.8
53
134.6
in
cm
Header & Cover
10
25.4
Spindle Arms
80
203.2
Barrier
Passage Panels
In
cm
Now Part of
1950 Camino Vida Roble, Suite 150
Carlsbad, CA 92008
Tel: 760.438.7000 800.421.1587
www.aigismech.com • www.linearcorp.com
Copyright © 2011 Linear LLC
231465 A
|