INSTALLATION INSTRUCTIONS FOR PART 99-9009
APPLICATIONS
VW Touareg/Touareg2
2004-2010
99-9009
KIT FEATURES
• DIN Head Unit Provision with Pocket
• ISO DIN Head Unit Provision with Pocket
KIT COMPONENTS
A) Radio Housing • B) ISO Snap-In Brackets • C) Trim Plate
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Wiring Harness:
• 70- 9003 - VW Toureg Harness 2004-up
Antenna Adapter:
B
A
• 40-EU55 Amplified VW Antenna Adapter
C
TOOLS REQUIRED:
86-9001 Radio Removal Tools (2 sets) • Flat Blade Screwdriver
1-800-221-0932
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
99-9009
2004-2010 VW TOUAREG
A
Disconnect the negative battery
terminal to prevent an accidental
short circuit.
1
2
Insert the long ends of the 86-9001
into the slots on the factory radio
and pull out to remove. (Figure A)
NOTE:
Flat edge of key should point outward.
1
99-9009
DIN HEAD UNIT PROVISIONS
A
Slide the DIN cage into the Radio
Housing and secure by bending the
metal locking tabs down. (Figure A)
1
2
Slide the aftermarket head unit into
the cage and secure. (Figure B)
B
2
99-9009
ISO DIN HEAD UNIT PROVISIONS
A
Mount the ISO Brackets to the head
unit with the screws supplied with
the unit. (Figure A)
1
2
Slide the head unit into the radio
opening until the side clips engage.
(Figure B)
B
Snap the Trim plate into the Radio
3
Housing. (Figure B)
3
99-9009
A
B
A)
B)
C)
D)
Strip wire ends back 1/2"
Twist ends together
Solder
Tape
C
D
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adapter and making the
connections as shown. (Isolate and indi-
vidually tape off the ends of any unused
wires to prevent electrical short circuit)
1
Re-connect the negative battery terminal
and test the unit for proper operation.
2
Reassemble radio and dash assemblies in
reverse order of disassembly.
3
4
99-9009
5
INST99-9009
1-800-221-0932
Rev. 04-27-10
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
INST99-9009
|