NEC CDC TO3 User Manual

INSTALLATION GUIDE FOR:  
CD CHANGER INTERFACE  
for TOYOTA VEHICLES  
Model CDC-TO3  
128-5524  
IMPORTANT  
Works in conjuction with Audiovox 6 Disc and 10 Disc CD Changer (except P-1000)  
For use with Toyota vehicles factory radios as listed in the following vehicles:  
1998-99 Corolla  
1998-99 Land Cruiser  
1998-99 Paseo  
1998-99 4-Runner  
1998-99 RAV4  
1998-99 Sienna*  
1998-99 Avalon  
1998-99 Camry  
1998-99 Celica  
1998\  
1998-99 Tacoma  
1998-99 Tercel  
T-100  
* NOTE: CDC-TO3 does not work in conjunction with Sienna steering wheel controls.  
Compatible with following Toyota factory radio models in above vehicles (model number is printed on face  
panel of radio):  
16808  
16810  
51800  
56808  
A51707  
A51801  
A56409  
AD1701  
AD1702  
AD6401  
AD6801  
AD6802  
11801  
11802  
16408  
16410  
CAUTION: FOLLOW THE CONNECTION SEQUENCE DESCRIBED BELOW TO ENSURE PROPER  
RECOGNITION OF THE CD CHANGER BY THE FACTORY RADIO.  
DO NOT FORCE CONNECTORS TOGETHER. LINE UP LOCATING TABS AND CAREFULLY  
MATE CONNECTORS.  
INSTALLATION INSTRUCTIONS FOR THE CDC-TO3: (See Installation Diagram)  
1. Mount the CD Changer in the rear of the vehicle. Refer to the installation instructions supplied with  
the CD Changer.  
2. Be sure the ignition switch and the radio are in the off position.  
CAUTION: If not, the radio will not recognize the changer.  
3. Remove the factory radio from the dash panel.  
4. Disconnect the power/speaker harness between the car and the radio.  
5. Connect the CDC-TO3 to the Changer using the 5 Meter DIN Cable supplied with the CD Changer.  
6. Plug the 12 Pin Connector from the CDC-TO3 into the mating socket on the rear of the factory radio.  
7. Re-connect the radio power/speaker harness.  
8. Reset the Changer and insert the CD magazine.  
9. Re-install the radio into the dash panel.  
10. Turn on the ignition and radio and perform an operation check.  
OPERATION CHECK:  
1. Load CD’s into the CD Changer magazine and insert the magazine into the changer.  
2. Start vehicle and allow CD Changer to cycle. Perform a brief functional test to verify proper  
operation according to the Owner’s Manual.  
© 1999 Audiovox Corporation, 150 Marcus Blvd., Hauppauge, N.Y. 11788  
Page 1  

Philips BDP2600 User Manual
Panasonic ED250 BCP User Manual
Panasonic CQ C9801U User Manual
Panasonic AJ SD945E User Manual
Nikon Coolpix 5000 User Manual
Nikon 3318 User Manual
Kenwood KRC 208S User Manual
Kenwood KDC C601 User Manual
Kenwood Excelon Music Keg KHD CX910 User Manual
Kenwood DPX MP4030 User Manual