Apollo Stainless Steel Blender
Model:
62000/
6 2 0 0 7
complies with
INTERNATIONAL
IEC60335
SAFETY SPECIFICATIONS
5 0 0 W
PLEASE READ ALL INSTRUCTIONS BEFORE USE
2 y e a r g u a r a n t e e
remove it.
Before first use
Useful tips:
All parts of the blender are to be thoroughly
cleaned before being used for the first time.
•
To achieve the best results when pureeing
solid ingredients, place small portions into
the glass jar one by one instead of placing a
large quantity all at once.
If you are processing solid ingredients, cut
them into small pieces (2-3cm) first.
When mixing solid ingredients start off first
with a small amount of liquid. Gradually add
more and more liquid through the opening
in the lid.
Always place your hand on top of the
blender when you are operating the device.
For stirring solid or very thick liquid
ingredients we recommend that you use
the blender in impulse mode to prevent the
blades from becoming stuck.
Assembling the Jar:
1.Put the rubber sealing ring (5) on the inner edge
of the blade unit (6).
2.Put the blade unit with sealing ring into the cup
base (7).
3.Inset the ring (4) on the bottom of jar first, then
Insert the assembled cup base onto the bottom
of the jar (3) and turn clockwise to secure tightly
in place.
•
•
•
•
4.Mount the Measure Cup (1) onto the Lid (2).
5.Secure the Lid onto Jar and press into place.
Inserting the Jar:
1.Make sure that the blender is switched off
(Switch in the ‘0’ setting).
2.Place the jar assembly (9) on to the motor base
(8) and press down until securely engaged.
Motor Base:
Never immerse the motor base in water. Wipe it
only with a damp cloth.
Instructions for Use
Simple cleaning/ rinsing out the assembled glass
jar:
Empty the glass jar and fill it with water. Place the
glass jar on the motor base and turn the switch
several times into the ‘P’ setting. Empty the glass
jar and rinse until clean.
1.Place the foodstuff you wish to process into the
jar.
2.Place the lid on the jar and close securely. Place
the measuring cap into the hole in the lid and
turn clockwise to lock.
3.Place your hand on the lid and apply firm
pressure before switching the unit ON. The
appliance is fitted with a safety switch and
requires sufficient downward pressure to
operate.
WARNING: THE JAR OR ANY PART OF THE
JAR ASSEMBLY IS NOT BE CLEANED USING A
DISH WASHER. USE OF A DISH WASHER MAY
RESULT AND DAMAGE AND THE WARRANTY
WILL BE VOID.
4.Switch on the motor base to desired setting:
Speed setting
1
2
Use
SAVE THESE INTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD USE
ONLY!
for light usage with liquids
for more solid consistency –
for mixing liquids and solid
foodstuffs
Warranty
0
stop operation
P
for ice crushing & short,
powerful impulse movements
We guarantee that this product has been
thoroughly inspected and tested before
dispatched and is free from mechanical and
electrical defects. Should defects due to faulty
material or workmanship develop within one year
from date of purchase, under normal domestic
use, the appliance will be repaired free of charge.
Note: If this product is used commercially the
guarantee is limited to 90 days.
(The switch does not permanently engage in the
‘PULSE’ setting. You have to hold the switch in
the ‘PULSE’ setting or turn it repeatedly into the
‘P’ setting)
WARNING: NEVER LEAVE THE APPLIANCE
ALONE WHILE IN OPERATION.
Kindly retain your purchase slip for this must be
presented if making a claim under the terms of
the guarantee. If such proof is not available the
product shall be deemed to be older than one
year and a charge for service and \ or spares will
After using the blender, always move the switch
into the ‘0’ setting and pull out the mains plug.
To remove the glass jar simply lift it off the motor
base. You do not have to rotate the glass jar to
be applicable. Should your appliance require
attention or appear not to be operating properly,
please take it to the retailer from whom it was
purchased, together with all parts and your
purchase slip.
This guarantee does not cover wear and tear
or damaged cause by over-loading negligence,
accidental or improper use. Any changes will
invalidate the guarantee, as would any attempted
repair.
SERVICE
Before returning your product for service or repair
– check the following:
• Your household mains supply socket is working
properly.
• The mains supply circuit is not overloaded.
• The instructions for use have been followed
carefully.
If service becomes necessary within the
guarantee period the appliance should be
returned to the retail outlet where purchased or
carefully packed and marked “fragile-handle with
care“ and sent carriage paid to the address below.
(Postage is not refundable) Service outside the
guarantee period is still available but this will be
chargeable.
27 Nourse
Avenue Epping
2
Cape Town
P.O. Box 975 Eppindust 7475 South Africa
Tel: +27 21 534 8114 Fax: +27 21 534 8086
Service Centre Share Call: 086 111 5006
w e b : w w w. c r e a t i v e h o u s e w a r e s . c o . z a
|